@flame1.carol wrote:
This is my first post so I hope my question is in the right place. I have a picture of a lion that I want to put into Glow in order to use the neon filters. I do not want the background, just the lion, so I was trying to use Remask to remove the background before using Glow.
After using Remask, I send the lion to Glow, but the entire image goes. When it comes back from Glow, the mask doesn't look very good because it chops off some of the neon lines that Glow added. I can't imagine sending the image to Glow first and then trying to create the mask so I haven't tried that yet.
How do you suggest I approach this? Is there a way to create a cut-out of the lion from the mask before sending to Glow? Should I try using Remask after Glow?
I'm open to all advice and suggestions. I've only had the products for about a week and I've tried watching a number of Remask and Glow videos on YouTube, which definitely helps, but I haven't seen one yet that fits my situation and I'm sort of floundering about.
Thank you!
Carol
Posts: 7
Participants: 3